An all-in-one groovebox for building reggae riddims and mixing dub, live. Made for iPhone and iPad.
TowerDub started from a simple wish: a single, tactile instrument where you program a reggae riddim and then perform the dub, the way a mix was once played on the desk, in one live take.
It is a groovebox in the compact sense: one rack that shows every instrument and its mixer controls at a glance, and one editor per instrument for the details. The sound and the workflow follow the dub tradition: cut-outs, echo throws, filter sweeps and a siren, all played live and recorded as they happen.
Sine-based low end, soft saturation, dark filter ceilings and a delay that wears down each repeat. The aim is a worn, muted sound, not a shiny one.
Knobs are dragged horizontally so the page can still scroll. The keyboard maps to scale degrees, not to a piano. Everything is made for fingers on glass.
Nine instruments, five effect blocks, one transport. Volume, delay send, reverb send and a CUT button sit on every line.
Place steps on a 16th-note grid for four drum voices, and notes for bass, chords, lead, pads and a sampler. Each instrument has four patterns and its own length, from 16 to 128 steps.
Every instrument has five sound controls, and a long press on a step lets those controls change that step alone (parameter locks). Each step can also carry a trigger probability.
Each line has its own delay send and reverb send, feeding a tape-style echo and a dark reverb shared by the whole rack.
Hit CUT on a line, route instruments through the resonant Dub Filter, throw echoes, freeze the delay, play the siren. The mix is the performance.
Dub Record captures the whole stereo mix to a WAV file, ready to share from the system share sheet.
Every line is a separate bus with its own Vol, Delay send, Reverb send and CUT. Each instrument has its own colour in the app, repeated here.
The rack also holds Delay, Reverb, Dub Filter, Dub Siren and a Mic input.
All instrument voices are custom synthesis written for the app. Only the Delay and Reverb use Apple's built-in audio units. Several instruments have a Morph knob: one macro that moves the timbre across several keyframes, designed so that no position sounds better just because it is louder.
A sine from 27 to 110 Hz with an exponential decay of 40 to 390 ms. Punch adds a downward pitch glide and, in its upper half, a very short high-passed noise click. Tone adds second and third harmonics and a bell boost at 150 Hz. Drive is tanh saturation blended with the dry signal; the click is added after it, so it stays sharp.
A sine body (140 to 320 Hz) plus white noise band-passed around 1.6 to 2.4 kHz. Snap sets how fast the noise comes in, and a small rimshot-style click is always present.
White noise through a 6 to 10 kHz high-pass. Grain adds metallic partials above its midpoint (inharmonic ratios) and a gated shaker texture below it. Choke shortens the length of the hat.
Modal synthesis: four inharmonic sine modes on a base between 90 and 400 Hz. Morph slides the mode ratios from a tom to a bell. Resonance sets the size and tail of a shell resonator, and a short noise transient gives the attack.
The reference sound is a pure sine. Morph moves from a sine with a sub-octave, through the pure sine at the centre, to a triangle with a trace of saw. Drive saturates before a two-pole low-pass (80 to 1,600 Hz, logarithmic). The filter cutoff follows each note's envelope: it opens on the attack and settles back, which gives the classic dub "wow". Sequenced notes end smoothly just before the next note starts, like a monophonic bass line.
Each key plays a diatonic triad (root, third, fifth) from the active scale, so a chord always agrees with the bass. Warmth is tanh saturation applied to each of the three voices before they are summed, which avoids the muddy intermodulation of saturating a whole chord. Spread detunes the third and fifth by up to 35 cents. Sweep is a resonant low-pass that opens on each hit and closes again with the chord. Morph runs from sine, through triangle, to saw and pulse.
A held, breathing voice. Below the centre of Morph, drawbar organ harmonics with a hint of preamp grain; at the centre, a pure sine; above it, a triangle moving to a saw with a formant resonance and breath noise that follows the note. Filter covers roughly 220 Hz to 3 kHz, Width detunes left and right oscillators by up to 18 cents, and Attack and Decay shape a slow swell and a soft release.
A bed of low-passed noise (Grain sets how dark it is) under a tonal layer built from detuned voice pairs (Swarm). A slow LFO makes the filter breathe, and Morph also adds a very slow pitch drift of a few cents. The envelope is long, about two seconds.
Record a sound with the microphone (tap REC, tap again to stop, up to 8 seconds), trim the start and end on a waveform, then place it on the grid. Four slots, each with its own patterns. Pitch is varispeed over plus or minus one octave. Tape is a one-knob macro: towards the left, a darker, worn tape with saturation and gentle wow and flutter; towards the right, a thin "radio" band.
Version 1.1 adds an interactive tutorial for people who have never used a music-making app. A welcome screen offers to start or skip it. Each step puts a ring on the real control and waits for you to do the gesture, then moves on.
It builds a riddim step by step in a throwaway project: drums, chords, bass, a live-recorded melody, a recorded sample, delay and reverb, then a live dub that is recorded and exported. If you finish at least one section, the result is kept as "My First Riddim". It can be replayed any time from the project menu.
TowerDub is self-contained: there is no MIDI, no AUv3 plug-in mode and no import of external audio files. Samples are recorded inside the app.